View:
Introduction
Specifications
Environmental
Performance curves
Physical characteristics
Soldering/Washing

Datasheet 3D Model

Request Quote:

;

CP336FRA172

For more information and specification about the part.

Go to series

Specifications

Part number 1	Lines	Common mode peak impedance (Ω)	Cutoff frequency (MHz) 2	Common mode attenuation typ (dB)			Inductance min (nH) 3	Irms (mA) 4	DCR max (Ω) 5	Isolation Voltage (Vrms) 6
Part number 1	Lines	Common mode peak impedance (Ω)	Cutoff frequency (MHz) 2	10 MHz	100 MHz	500 MHz	Inductance min (nH) 3	Irms (mA) 4	DCR max (Ω) 5	Isolation Voltage (Vrms) 6
CP336FRA172MAZ	2	640 @ 1800 MHz	1800	2.3	6.7	22	84	500	0.25	250

Notes

When ordering, please specify termination and testing codes: e.g. CP336FRA902MAZ.
Frequency at which the differential mode attenuation equals −3 dB.
Inductance is measured on an Agilent 4286A (or equivalent) with a Coilcraft SMD-A test fixture using the listed correlation.
Current per winding that causes a 20°C rise from 25°C ambient.
DCR is measured on a Keithley 580 Micro-ohmmeter (or equivalent) with a Coilcraft CCF858 test fixture.
Winding to winding isolation (hipot) tested for one minute.

Termination:

A = Gold over nickel over silver-palladium-glass frit.
C = Tin-lead over gold over nickel over silver-palladiumglass frit. (Special order, added cost)
F = Tin-silver-copper over gold over nickel over silverpalladium-glass frit. (Special order, added cost)

Testing:

Z = Unscreened
H = Group A screening per Coilcraft CP-SA-10001

All screening performed to the document’s latest revision.
Custom screening also available.

Environmental

Ambient temperature range:

–40°C to +85°C with Irms current.

Storage temperature range:

Component: –55°C to +105°C.
Tape and reel packaging: –55°C to +80°C.

Maximum part temperature:

+105°C (ambient + temp rise).

Failures in Time (FIT) / Mean Time Between Failures (MTBF):

See FIT/MTBF Calculations

Performance curves

Typical Attenuation (Ref: 50 Ohms)

Typical Impedance vs Frequency

Physical characteristics

General specification

Core Material:

Ferrite

Weight:

14.9 – 20.0 mg

Packaging:

2000 per 7″reel; Plastic tape: 8 mm wide, 0.23 mm thick, 4 mm pocket spacing, 1.14 mm pocket depth.

Soldering/Washing

Moisture Sensitivity Level (MSL):

1 (unlimited floor life at <30°C / 85% relative humidity).

Resistance to soldering heat:

Max three 40 second reflows at +260°C, parts cooled to room temperature between cycles.

Refer to Soldering Coilcraft Components before soldering.